I have successfully installed 14 of 16 blades successfully using Auto Deploy and a VERY PLAIN / Vanilla host profile.
The sole purpose is to get ESXi5 on each blade and then swing the installation to a STATEFUL cached installation (local installation).
However, two blades refuse to complete the profile application without error.
They complain about " CP_NO_VALID_PARTITION_FOUND" in the syslog.log file and even if I manually place a VMFS5 volume, it still refuses to complete without error.
This leaves these two hosts in Maint. mode and they fail to come online.
Note that my expectation is that these servers can start with a completely ERASED set of drives, where only the RAID controller has made a 0+1 disk of the two on board drives.
It SHOULD install just fine on that, but NOT on these two servers.
Attached is a the Syslog....
================================
ANY help is appreciated.